The term equilibrium
has often to be used in economic analysis.
In fact, Modern Economics is sometimes called equilibrium analysis. Equilibrium means a state of balance. When forces acting in opposite directions are exactly equal,
the object on which they are acting is said to be in a state of equilibrium.
Types of Equilibrium
Basically, there are three types of any equilibrium:
(a) Stable Equilibrium: There is stable equilibrium, when the object concerned, after having been disturbed, tends to resume its original position. Thus, in the case of a stable equilibrium, there is a tendency for the object to revert to the old position.
(b) Unstable Equilibrium: On the other hand, the equilibrium is unstable when a slight disturbance evokes further disturbance, so that the original position is never restored. In this case, there is a tendency for the object to assume newer and newer positions once there is departure from the original position.
(c) Neutral Equilibrium: It is neutral equilibrium when the disturbing forces neither bring it back to the original position nor do they drive it further away from it. It rests where it has been moved. Thus, in the case of a neutral equilibrium, the object assumes once for all a new position after the original position is disturbed.
In the following figure 2, the stable equilibrium is shown. When in equilibrium at point P, the producer produces an output OM and maximises his profits. In case the producer increases his output to OM2 or decreases it to OM1, the size of profits is reduced. This automatically brings in forces that tend to establish equilibrium again at P.
Figure 3 represents the case of unstable equilibrium. Initially the producer is in equilibrium at point P, where MR = MC and he is maximising his profits. If now he increases his output to OM1, he would be in equilibrium output at point P1, where he will obtain higher profits, because, at this output, marginal revenue is greater than marginal cost. Thus there is no tendency to return to the original position at P.
Figure 4 represents the situation of neutral equilibrium. In this case, MR = MC at all levels of output so that the producer has no tendency to return to the old position and every time a new equilibrium point is obtained, which is as good as the initial one.
Other Forms of Equilibrium
Short-term and Long-term Equilibrium:
may be short-term equilibrium or long-term equilibrium as in case of short-term
and long-term value. In the
short-term equilibrium, supply is adjusted to change in demand with the existing
equipment or means of production, there being no time available to increase or
decrease the factors of production. However,
in case of long-term equilibrium, there is ample time to change even the
equipment or the factors of production themselves, and a new factory can be
erected or new machinery can be installed.
Partial equilibrium analysis is the analysis of an equilibrium position for a
sector of the economy or for one or several partial groups of the economic unit
corresponding to a particular set of data.
This analysis excludes certain variables and relationship from the
totality and studies only a few selected variables at a time.
In other words, this method considers the changes in one or two variables
keeping all others constant, i.e., ceteris paribus (others remaining the
same). The ceteris paribus is
the crux of partial equilibrium analysis.
The equilibrium of a
single consumer, a single producer, a single firm and a single industry are
examples of partial equilibrium analysis. Marshall’s
theory of value is a case of partial equilibrium analysis. If the Marshallian method (i.e., partial equilibrium
analysis) is to be effective, even in its own terms, when applied to a
hypothetical and idealised market, it necessary that the market should be small
enough so that its inter-dependence with the rest of the hypothetical economy
could be neglected without much loss of accuracy.
(i) Consumer’s Equilibrium: With the application of partial equilibrium analysis, consumer’s equilibrium is indicated when he is getting maximum aggregate satisfaction from a given expenditure and in a given set of conditions relating to price and supply of the commodity.
(ii) Producer’s Equilibrium: A producer is in equilibrium when he is able to maximise his aggregate net profit in the economic conditions in which he is working.
(iii) Firm’s Equilibrium: A firm is said to be in long-run equilibrium when it has attained the optimum size when is ideal from the viewpoint of profit and utilisation of resources at its disposal.
Equilibrium: Equilibrium of an industry shows
that there is no incentive for new firms to enter it or for the existing firms
to leave it. This will happen when
the marginal firm in the industry is making only normal profit, neither more nor
less. In all these cases; those who have incentive to change it have no
opportunity and those who have the opportunity have no incentive.
General Equilibrium Analysis:
Leon Walras (1834-1910), a Neoclassical economist, in his book ‘Elements of
Pure Economics’, created his theoretical and mathematical model of General
Equilibrium as a means of integrating both the effects of demand and supply side
forces in the whole economy. Walras’
Elements of Pure Economics provides a succession of models, each taking into
account more aspects of a real economy. General equilibrium theory is a branch of theoretical
microeconomics. The partial
equilibrium analysis studies the relationship between only selected few
variables, keeping others unchanged. Whereas
the general equilibrium analysis enables us to study the behaviour of economic
variables taking full account of the interaction between those variables and the
rest of the economy. In partial
equilibrium analysis, the determination of the price of a good is simplified by
just looking at the price of one good, and assuming that the prices of all other
goods remain constant.
is different from the aggregate or macro-economic equilibrium.
General equilibrium tries to give an understanding of the whole economy
using a bottom-top approach, starting with individual markets and agents.
Whereas, the macro-economic equilibrium analysis utilises top-bottom
approach, where the analysis starts with larger aggregates.
In macro-economic equilibrium models, like Keynesian type, the entire
system is described by relatively few, appropriately defined aggregates and
functional relationships connecting aggregate variables such as total
consumption expenditure, total investment, total employment, aggregate output
and the like. In macro-economic
analysis, many important variables and relationships tend to be disappeared in
the process of aggregation.
There are two major
theorems presented by Kenneth Arrow and Gerard Debreu in the framework of
(i) The first fundamental theorem is that every market equilibrium is Pareto optimal under certain conditions, and
The second fundamental theorem is that every Pareto optimum is supported
by a price system, again under certain conditions.
Uses of General Equilibrium
1. To get an overall picture of the economy and study the problems involving the economy as a whole or even large segments / sectors of it.
2. It shows that the quantities of demanded goods / factors are equal to the quantities supplied. Such a condition implies that there is a full employment of resources.
3. It also provides with an ideal datum of economic efficiency. It brings out the fact that long-run competitive equilibrium is a standard of efficiency for the entire economy. Only when the competitive economy obtains general equilibrium shall its economic efficiency be at its peak and there shall be no further gains made by any reallocation of resources.
4. General equilibrium also represents the state of optimum production of all commodities, because there can be no over-production or under-production under such conditions.
5. It also provides an insight into the way the multitudes of individual decisions are integrated by the working of the price mechanism. It, therefore, solves the fundamental problems of a free market economy, viz., what to produce, how to produce, how much to produce, etc. This analysis shows that such decisions with regard to innumerable consumers and producers are co-ordinated by the price mechanism.
6. The general equilibrium analysis also gives us the clue for predicting the consequences of an economic event.
It also helps in the field of
public policy. The
formulation of a logically consistent public policy requires a complete
understanding of the various sector markets and aspects of individual
decision-making units, and the impact of policy on the whole economy.
Limitations of General Equilibrium Analysis
1. The Walrasian general equilibrium system is essentially static. It treats the coefficient of production as fixed. It considers the supply of resources to be given and consistent. It also takes tastes and preferences of the society as fixed.
2. It ignores leads and lags, for it considers everything to happen instantaneously. It is supposed to work just in the same way as an electric circuit does. In the real world, all economic events have links with the past and the future.
3. Walrasian general equilibrium analysis is of little practical utility. It involves astronomical volumes of calculations for estimating the various quantities and practices. This makes its application practically impossible. Even the use of computers cannot be of much help because such a system cannot aid in collecting and recording the innumerable sets of prices and quantities that are required to formulate these equations. The critics further argue that even if such a solution exists, the price mechanism may not necessarily cover it.
Last but not least, the general
equilibrium analysis falls to the ground as its star assumption of perfect
competition is contrary to the actual conditions prevailing in the real
General Disequilibrium (Keynesian Theory)
economics thinks in terms of a market system in which supply equals demand in
every market, so that no unemployment could ever occur.
But this is an assumption. Keynes
suggests a market system in which Disequilibrium can occur in some markets,
including labour market, and in which the disequilibrium can spread contagiously
from one market to another. Keynes’
idea was that, when this spreading disequilibrium settles down, there would be a
kind of equilibrium – not supply and demand equilibrium, but often termed as ‘general
Take an example of a commodity, say cellular telephone sets, its equilibrium of demand and supply is shown in the following figure:
With a reduction of demand for cellular phones, any economist would expect a reduction in the quantity of that commodity produced. Neoclassical economics leads us to expect that the price would drop to P3 and output cut back to Qe. At the same time, a certain number of workers would be laid off and would switch their efforts into their second best alternatives, working in other industries, perhaps at somewhat lower wages. But the ‘disequilibrium model’ states that the production and layoffs would go even further, with output dropping to Qd. A reduction in income does not only reduce the demand for cellular phones, but it also reduces the demand for all other normal goods as well. This disequilibrium will spread contagiously through many different goods markets, through the effect of disequilibrium on income. So every other industry will face a reduction in demand because of the reductions in productions in many other industries.